Model 87 Technical Information

Description

-The left and right main side plates of the shear and flanger are fully surface ground on both faces. 

-The two main Shaft Housings for the Shear and the lower Main Shaft Housing for the  Flanger are made of continuous cast iron. The Flanger's Upper Main Shaft Housing is made  of steel. 

-The two Blade Shafts and the two Roll Shafts are made of heat treated alloy steel.

​-These four Main Shafts have quality radial and thrust bearings.

-The Pivot Housings for the Shear and the Flanger use Timken bearings.

-The Shear Blades are made of tool steel and are heat treated.

-The Flanging Rolls are made of alloy steel and are heat treated.

-The center rail is precision ground on the sides, top, and bottom.

​-The Center Carriage Plates are made of continuous cast iron.

-The Center Carriage Assembly has 8 CAM followers for exact, smooth movement as it  glides up and down the rail.

-The Vacuum Seal is made by Anver. The Vacuum Pump is made by Piab.

-The Hydraulic Motors are made by White Drive Products.